Long Frame Bushing

You are here


This is our extended front shackle hanger specific bushing designed to fit the frame tubes of a front solid axle suspension setup!

It is 40% longer than our small spring bushing and made from the same High Quality urethane. Made in the USA by Energy Suspension.

Sold individually! Four required per truck.

ID: 18 mm, OD: 29.75 mm
Length: 45.75mm


High Quality Spring Bushing Application Table

The following table shows bushing
configurations for aftermarket springs and hangers.

BushingType / LocationQuantity per truckLink

Large (39.50mm O.D.)
Rear Spring Front Eyelet
Rear Spring Rear Eyelet
Small (29.75mm O.D.)
Front Spring Front Eyelet
Front Spring Rear Eyelet
Rear Shackle Hanger
Small, Long (29.75mm O.D.)
Front Shackle Hanger


Proposition 65 Warning for California Consumers

WARNING: Products we sell can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.p65warnings.ca.gov.

Energy Suspension's Performance Polyurethane Components

We are now using Energy Suspension!

Soft or worn-out O.E.M. rubber bushings and mounts will cause poor handling and alignment, excessive body roll and dangerous drivetrain movement. Energy Suspension's Hyper-Flex™ material is the result of years of experience working with and formulating polyurethane materials perfected to outlast and outperform rubber. Careful selection of material firmness or durometer is used for each specific application on the vehicle's suspension and chassis to ensure improved vehicle control without compromising ride quality.


Why we recommend Energy Suspension's Hyper-Flex™:

  • Ultimate in Performance and Durability
  • Guaranteed to outlast rubber by a minimum of 5 to 1
  • Impervious to gas, oils, and other petroleum products
  • Will not rot or deteriorate from smog, ozone, or road salts
  • Formulated for its specific purpose (correct hardness for each application)
  • Soft enough for a smooth ride and yet firm enough for the most demanding environment

Energy's Hyper-Flex™ is superior performance polyurethane which has proven itself under the most demanding conditions on the race track, off-road, and street performance driving. Hyper-Flex™ components are a great value, not only because they will outlast rubber 5 to 1, but because they are a cost effective performance improvement for your car or truck. Whether domestic or import, front, rear or 4WD, old or new, your vehicle will achieve that level of performance that has made Energy Suspension the most asked-for name in performance polyurethane components. All Hyper-Flex™ components are proudly Made In America!

Energy Suspension Is The World's Largest Manufacturer
Of Precision Engineered Polyurethane Components

Made In America!