Heavy Duty Shift Seat
It's common for the factory shift lever ball seat to wear, crumble and disintegrate over time. This often results in a sloppy or loose transmission shifter. The factory seat is soft and is squeezed into position. Therefore it is fragile. We took a different approach. Instead of squeezing the seat into place, we machine a strong, rigid piece that rotates & drops into position. This allows us to make our seat from stronger, longer lasting USA-made Delrin. Our new heavy duty seats will far out last the stock units and will greatly reduce shifter slop.
Heavy Duty Shift Socket
In addition to the Seat, there is a Socket which attaches to the end of the shift handle and operates the shift shoe inside the transmission. The factory socket is also made from a softer material which wears over time, and swapping this out with our HD version also makes a massive improvement to shifting performance.
NEW Combo Package with $5.02 Flat Rate Shipping
Over 99% of our customers upgrade both Seat & Socket at the same time. Making these two Heavy Duty components as a one-product Combo was only natural and we are happy to now offer this with a low flat rate shipping charge of only $5.02! Alaska, Hawaii, and International orders: If this is your only shopping cart product, then the website will allow the order to go through with free shipping. We will then contact you to arrange for a non-48-state or international shipping service & charge. Thank you for your understanding!
In general, this fits all 1981 and newer manual transmission Toyota 2WD and 4WD trucks, including T100s, Tundras, Tacomas, FJ Cruisers, and 4Runners, but excludes the 1985-88 W56-A/B (uses red seat listed above).
Also fits rear wheel drive Cressida's, Celica's & Supra's!
This is our H.D. Transfer Case Shift Handle Seat
If your transmission is not listed, don't despair! While we cannot guarantee if our seats will fit other applications, they have been found to fit other applications based on the bore diameter of your transmission's shifter base: Our Blue seats are designed for a 39mm bore, our Red seats are designed for a 41mm bore, and our White seats are designed for a 42mm bore. If you order a seat and find it doesn't fit, you will be subject to our restocking fee if returned.
Demo video from a customer install of both our
Heavy Duty Seat & Socket into a single-turbo Supra
Proposition 65 Warning for California Consumers
WARNING: Products we sell can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.p65warnings.ca.gov.