Rocks are hard. Fight back with with our ultra tough American-made U.S.A. steel rear bumpers.

Our rear bumpers are built to fit your specific vehicle. Made from 1-3/4" round .120 USA-Made tubing and designed with a 4-bolt frame mount system with side bracing. The end result is a very ridgid bumper that can easily bear the load of your truck with a Hi-lift jack (or similar) or an ancor point.

Our unique receiver design does not interfere with the stock spare tire location nor the tail gate, which is especially nice since we use heavy duty D.O.T.-recommended seamless square 2.5" x 1/4"-wall receiver tubing. Watch out for other bumper manufactures who us e formed and stressed material for their receivers!

The nice "M C" plate provides a strong and sturdy steeping point to help with loading and unloading of your cargo.

Features two D-Ring shackle mounts, a heavy duty 2-1/2" seamless square receiver, and corner body and light protection.

They are shipped unpainted. We recommend using Restoleum spray paint to give it a lasting finish. Also, for most applications, two small body notches are required on the bed skirt below the tail gate hinges to clear the sturdy 1/4" thick integrated frame mount rails.

These bumpers are extremely sturdy and could in theory tow a variety of trailers well, however they are NOT rated and we do NOT have any recommended weight or tongue loading information. Remember this is a Rock Crawler bumper, and a darn fine one too!

Read a comparison of our bumpers vs a competitor's "DOM" bumpers. Know what you are buying and buy with confidence!