Armor » Rear Bumper Rear Bumper for 4Runners
- UPDATED! Double-support D-Ring shackle mount!
- NEW! Full-length Turtle step plate with reverse flared holes!
- NEW! Two intermediate support beams for increased rear impact strength!
- NEW! DUAL frame bracket corner brace supports!
- NEW! Enlarged receiver hitch rear bracket for adding additional towing support beams!
- NEW! Angled corner protection for increased side impact strength!
- NEW! Increased side protection length - now closer to the rear tire for maximum body protection!
- NEW! $45 Flat Rate Shipping to the lower 48-states
- Click here for more images!
Flat Rate $45
Lower 48 States
Our 1984-1995 Toyota 4Runner rear bumpers are built to fit your specific vehicle. Made from 1-3/4" round .120 U.S.A. tubing and designed with a 4-bolt frame mount system with side bracing. The end result is a very rigid bumper that can easily bear the load of your truck with a Hi-lift jack (or similar) or an anchor point.
Our unique receiver design does not interfere with the stock spare tire location nor the tail gate, which is especially nice since we use heavy duty D.O.T.-recommended seamless square 2.5" x 1/4"-wall receiver tubing. Watch out for other bumper manufactures who us e formed and stressed material for their receivers!
Features two D-Ring shackle mounts, a heavy duty 2-1/2" seamless square receiver, and corner body and light protection.
They are shipped unpainted. We recommend using Restoleum spray paint to give it a lasting finish. Also, for most applications, two small body notches are required on the bed skirt below the tail gate hinges to clear the sturdy 1/4" thick integrated frame mount rails.
These bumpers are extremely sturdy and could in theory tow a variety of trailers well, however they are NOT rated and we do NOT have any recommended weight or tongue loading information. Remember this is a Rock Crawler bumper, and a darn fine one too!
(Starting at $399.00)
10% more dent resistant
...than a competitor's DOM steel.Click here to see the full report!
